Structural Drying & Dehumidification in Richmond

Steveston slabs start drying once vinyl or tile is up. Mats cover the high squares and air movers cross the concrete. An LGR builds grain depression in the low room so the air can take water off the slab. We log that drop daily.

The pinless grid and the grains go on the grain log every morning. Wet squares should close on a drier patch of the same pour and hold overnight. Wood at a door or a garage lip gets pins, with a target a few points from dry stock.

Brighouse townhouse slabs stay cool after a stack leak. The concrete between homes lags the corridor air. We lift the wet covering, set mats, and move air across the face. An LGR in the unit has to show grain depression or the deck keeps holding.

The grain log gets a daily grid of the unit and the shared edge. The target is a drier patch of that pour, stable overnight. Plates on the concrete get pins and a wood standard from a dry length. Both lines agree before the mats come up.

East Richmond garage slabs wet at the edge and stay cool. Hamilton houses wick along the perimeter the same way. We clear the wet zone, lay mats, move air, and run an LGR that still shows grain depression when the big door has been shut.

The grain log tracks the edge against the inner field each morning. Concrete should even out and hold overnight. A wood sill at the man door gets a pin and a target a few points from dry wood. Grains in and out sit on the same line so we can see the depression.

Seafair and Broadmoor floors sit on slab, and the covering hides the moisture. The layer comes up before the concrete can release. Mats and air then own the face, and an LGR builds grain depression in a low house. We check the grains the same day.

Daily pinless squares fill the grain log. The wet field should meet a drier patch and hold overnight. Wall plates on the slab get pins and a dry standard a few points off. The log stays open while either number is still falling.