Mold Removal in Port Coquitlam

Citadel Heights plates leave when a basement was finished over the last flood and the colony stayed on the wood. We set poly, run negative air, and cut the lower wall on a clean line. Board, batts, and soft plate go into bags before they leave the zone.

Hard plate gets a HEPA vacuum on every face we can reach. The stair stays taped. What leaves the house is that lower assembly. Closing the same wall again without the bag-out would screw new board onto the colony that the first finish left behind.

Oxford Heights walls get the cut along the old water line, where the paper and the plate are colonized. Negative air holds the basement. Strips go into bags at the wall. The line is in gypsum that is still clean and tight.

Riverwood basements that were finished on the same kind of history follow that bag-out. Studs that stay are HEPA vacuumed. Swollen trim leaves with the board. Poly keeps the rest of the lower floor clean, and the bags go out sealed by the shortest path.

Mary Hill crawls on the older streets lose joist fill and the debris that grew with it. We bag in the bay, pass the bags up sealed, and keep negative air aimed into the crawl. Poly stays on the hatch until the HEPA pass on the joists is done.

Lincoln Park houses with the same open ground use that bag-out. Soft wood leaves. Hard joists stay, vacuumed. The kitchen is not a dumping hall for loose batts. The truck is the destination, and the bags are closed before they see the stair.

Central Port Coquitlam rims lose the colonized edge fill through a side hatch when we have one. Poly rings the opening. Negative air pulls in. Bags are filled at the rim and carried out the side so the living room carpet never sees them.

The rim board gets a HEPA vacuum after the fill is gone. Surface growth on hard wood is cleaned under that vacuum. Fuzzy paper on the rim leaves with the batts. The bag-out ends when that material is on the truck, not when the hatch smells quieter.