Mold Removal in West Vancouver

Ambleside lower walls come off where the colony sits on the framing behind a tight finish. Poly goes up before the first panel. Negative air holds the room. We cut to a line in clean board, bag the sheets and the batts, and HEPA the studs that stay.

The finish hid the growth, so the paint face is not the guide. The guide is the cavity. Bags leave sealed, down a protected path. What leaves the house is that colonized board and fill. A hard stud stays, vacuumed, and the room outside the poly stays as we found it.

Dundarave millwork comes off the wall before we cut the cavity behind it. Pieces that are colonized or swollen leave in bags and do not go back. Sound pieces are set aside, wrapped, and kept out of the dust. Then the board and the batts behind them get the bag-out.

Negative air and poly hold the lower room. The cut line is in clean material. A HEPA vacuum finishes the framing that stays. The bag-out is both the ruined millwork and the colony it was covering. Leaving the cabinets on and spraying behind them keeps the mold in the wall.

British Properties lower levels get a full contained cut, because the finish is good enough to hide a wide colony. We hang poly, run negative air, and open the uphill wall to a marked line. Board, batts, and soft plate lengths go into bags inside the zone.

Sentinel Hill rooms with the same buried wall follow that bag-out. Framing we are keeping gets a HEPA pass while the poly is still sealed. Bags leave by the garage or the lower door, sealed. The rest of the floor finish stays covered. The takeout is the cavity, not a touch-up of the paint.

Caulfeild panels come off when the colony is on the back and on the framing. We contain the room first. Negative air runs while the panels and the batts go into bags. The cut stops in clean board. A HEPA vacuum takes the dust off the wood that will stay.

Horseshoe Bay lower rooms hide the same way, behind a finish that still looks presentable. The bag-out does not wait on a stain. If the cavity is colonized, that material leaves. Spray and a new panel over the old growth would put the mold back in the dark.