Water Damage Assessment & Inspection in Surrey

Newton bungalows and a lot of Whalley houses still have a shallow crawl or a low basement, and the lateral is old enough to surcharge. We open the hatch, pin the joists, and photograph the soil and the pier line. If the floor drain is the inlet, that leads the notes, because the category is then dirty water.

The moisture map lists bays, with sill and subfloor readings that show how far it climbed. A polybutylene supply leak in a 1980s house can wet the same crawl with cleaner water. We only write that category if we find the pipe or the stain path.

Cloverdale roofs let water in at valleys and around skylight curbs. Fraser Heights adds those same roof details, plus a window well on the uphill side. We meter the ceiling stain and two bays past it, because wet insulation is rarely the size of the paint mark. The upstairs floor gets a scan if the valley sits over a bathroom or a hall.

A thermal camera shows the cold insulation the stain has not reached yet. Photos include the ceiling, the skylight curb if we can see it from inside, and the meter. The moisture map separates a roof bay from a window-well wall. Those are different inlets.

South Surrey lots by the Nicomekl sit beside the ditch, and the slab can read wet along the outside wall after a long rain. We meter the slab edge, the baseboard, and the garage if it shares that wall. The outside photo shows the grade and the ditch, so the number has a source.

The moisture map marks how far the high reading comes into the room. Groundwater and a dishwasher line can both wet a kitchen, and the category changes the cleanup. We write the inlet we can defend. If the only evidence is a damp slab edge and a full ditch, that is what the page says.

Guildford houses with laundry on the upper floor leak into the ceiling and the insulation below, and the stain in the foyer is smaller than the wet batt. We meter the lid, then the laundry floor, the pan, and the wall behind the machines. Hoses, the standpipe, and the supply valves each get a look. The category depends on which of those failed.

Photos show the ceiling, the meter, and the machine connections. The moisture map lists both floors. A thermal camera traces the wet band across the joists when the paint is still even. The inspection stops at that record.