Mold Removal in Pitt Meadows

Bonson joists over open soil lose the colonized fill on a regular bag-out, because the growth sits there as an ongoing condition. We bag in the bay, seal the bags, and pass them out under negative air. Poly keeps the house clean. Hard faces get a HEPA vacuum.

The Pitt Polder edge uses that same hatch bag-out. Soft wood leaves. We are not scraping a little and leaving the batts. What leaves the house is the fill and the failed lumber. Spray in an open-soil crawl leaves the colony on the wood for the next season.

Downtown plates leave where a sump flood soaked the lower wall and the cavity was closed with the colony still on the wood. We cut on a clean line, bag the board and the batts, and bag the plate that crumbles. Negative air holds the room.

Poly runs to the stair. A hard plate stays and gets a HEPA vacuum. The bag-out is that lower band, on the truck the same day. New board is later. This visit takes the mold out of the house in bags.

Harris Road walls lose the lower board where the colony climbed off the plate. We mark the cut, hang poly, and keep negative air on while the strips and the batts go into bags. The remaining studs get a HEPA pass, and the barrier stays up until that is finished.

Central Pitt Meadows basements with the same lower band follow that bag-out. Swollen trim leaves. Clean board above the line stays. The path out is taped. We are removing a wall section, not fogging a closed cavity and wiping the paint.

Meadow Gardens cavities get poly and negative air before the first sheet comes off. The cut line sits above the colony. Board, batts, and soft plate leave in bags sealed inside the zone. The framing that stays gets a HEPA vacuum.

The floodplain crawl, if that house has one, is a separate bag-out through the hatch and it does not share loose debris with this room. Each load leaves sealed. The finish that covered the growth is part of what goes to the truck. A spray behind new board would put the mold back in the dark.