Mold Removal in Delta

Ladner baseboards come off because the colony is on the reverse and on the gypsum behind them. We bag the trim, cut the fuzzy board on a level line, and bag that too. Negative air holds the room. The slab edge gets a HEPA vacuum once the paper is gone.

There is often no crawl to open on these flat lots. The bag-out is the floor line, out the door in sealed bags. Poly keeps the next room clean. Hard board above the cut stays. Wiping the painted face of the trim leaves the growth on the slab side.

North Delta joists lose colonized fill through a low hatch. Poly rings it. Negative air pulls in. We bag the batts in the bay and pass them out sealed, then HEPA the wood that stays. Soft ends are cut back and bagged on their own.

Annieville crawls with the same low access use that bag-out. The house side stays clean because nothing loose crosses the floor. What leaves is the fill and the failed wood. A spray into a tight crawl leaves the batts hanging on the joists.

Sunshine Hills basement board comes off on a cut line where the colony climbed the paper. Batts behind that line go into bags. Negative air holds the room and poly guards the stair. Studs that stay get a HEPA vacuum before we drop the plastic.

The plate leaves where it is soft. A hard plate stays, detailed under the vacuum. Bags go up sealed. This is a wall takeout, the same day, and it stops at clean board. We are not opening the whole basement because one wall grew.

Tsawwassen walls at the window head lose the colonized sheathing and the interior board once wind-driven wetting has fed the cavity. We contain the room, cut to clean material, and bag the sheathing, the batts, and the gypsum. Negative air stays on.

Boundary Bay heads get that same bag-out when the colony is in the wall, not just on the paint. A HEPA vacuum finishes the framing that stays. The bags leave by a protected door. Spray on the interior paint leaves the sheathing exactly where the rain left the mold.